Insert the key into the ignition and turn the key to on.
Nissan altima abs light reset.
How to reset the service engine soon light on a nissan altima by don bowman.
Why is my abs light on after i replaced the wheel bearing if you have an abs light on after wheel bearing replaced you may have to also replace the other wheel bearing hub.
Follow these steps to reset the airbag status light on a nissan auto.
Here is how to reset it.
The wheel speed sensors are responsible for monitoring the wheel speed and sending it back to the computer system.
After turning the key to on wait until the light turns to off to start the blinking process and then switch the key off and remove the key.
One method which is the most convenient is to use a code scanner which you can purchase at any auto parts store.
There are two methods for resetting the service engine soon light on a nissan altima.
Click here to read the full article.
Watch the airbag light closely.
Notice that the light will stay on and then start blinking.
If you don t want to go to a dealership express lane you can often have this done at an auto parts store costco and many other auto repair locations.
If you have the airbag light it will show steady for a few seconds the manual says 7 secs after you turn the key from off to on but not start and then start to flash.
The light can be reset with an on board diagnostic tool.
Car makers sometimes install the toothed tone ring inside the wheel bearing hub and mount the wheel speed sensor on the outside of the hub.
My nissan altima 2012 abs brake tire pressure lights and key lights are all on even after it has been serviced.
Nissan altima abs light on causes.
The code scanner will display the codes automatically and has an.
Turn the key from off to on.